![]() ![]() To prevent unauthorized access to the BMC, make sure that the BMC IP address is set to a private non-routable IP address. Run the following command to specify the domain name. ![]() Run the following command to specify one or more DNS servers. Run the following command to specify the gateway address. When the prefix length is not specified, the value defaults to 32. If this error message appears, re-run the ifconfig inet eth0 / command to set the correct prefix length. If a prefix length is not specified, the error message Gateway address not on eth0 subnet: may appear when you try to exit Safe Mode. NOTE: Make sure to specify the prefix length in this command. Run the following command to specify an IP address and prefix length (subnet mask) for the management interface (eth0). #Terminal emulator mac address invalid argument serial numberRun the following command to set the HSN using the lower serial number provided in the pre-installation documents. When all issues identified above are corrected, type: Run the following command to display the prejoin configuration information that must be specified. Run the following command to enter the shellacess developer mode. The terminal emulator displays the prompt sn0> to indicate that the storage controller is in Safe Mode. In the terminal emulator, press Enter several times to initiate the connection to the storage controller. Use serial cable and do the following, READ BELOW precisely, also you are not supported if you dont have Dell deployment certificate, SC4020 deployment is cert only! ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |